Name: BD3.1 fast eddy current brake power supply interface
SKU: 1114
Availability: InStock

BD3.1 fast eddy current brake power supply interface

BD3.1 interface is an essential device used to power eddy current dyno brake. Is carries out following tasks:

Specification

Supply: 100-415VAC, 50-60Hz, 1-3 phase
Nominal brake current up to 22.5A, up to 30A
Fast brake torque control with microcontroller operated closed loop current control and fast discharge (demagnetization).
Thermal protection
Isolated input
Brake energy recovery to capacitor

SKU: N/A Category: PEREK

Torque control demonstration:

Speed control demonstration:

Specification

Supply	100-415VAC 50-60Hz 1-3 phase
Brake continuous current	BD3.1-22.5A: 22.5A @ 25°C 22.5A @ 40°C for 9 minutes 19A @ 40°C no time limits with 30m³/h airflow BD3.1-30A: 30A @ 25°C for 8 minutes 30A @ 40°C for 4 minutes 25A @ 25°C for 11 minutes 25A @ 40°C for 5 minutes no time limits with 30m³/h airflow
Brake discharge method	Fast discharge with storage capacitor
Typical full charge time (0 to full torque)	Less than 0.2s
Typical full discharge time (full torque to 0)	Less than 0.02s
Switching frequency	Adaptive, up to 4kHz
Brake current control	Controlled with microcontroller in closed loop
Current target control	Programmable current range Galvanically isolated CAN bus interface, CAN-BUS 2.0B, 500kBit
Diagnostics	CAN bus: Brake current Power stage temperature Switching frequency Additional information possible in future with firmware updates
Environment temperature range	−20°C – 50°C
Power stage thermal protection threshold	90°C
Operating humidity	0%-95% without condensation
Dimensions	14cm x 18cm x 12cm
Mass	1.7kg